Free Ground shipping on this item (lower 48 states only)

There are lots of good things to say about the all new 2010 Mazda Mazdaspeed 3 with 2.3L engine. This second-generation Mazdaspeed3 seems to be popping up all over. The 2010 Mazda Mazdaspeed3 is a high-performance 4-door hatchback equipped with a turbocharged 2.3 liter four-cylinder engine. It is comes with a six-speed manual transmission and a sport-tuned suspension system. The Mazda Mazdaspeed3 combines high performance, great handling and quality interior to achieve a practical, yet sporty, sedan that is perfect for the daily driver.

K&N Cold Air Intake System for 2010 Mazda Mazdaspeed3 with 2.3L engine

K&N has embraced the turbocharged 2.3 liter engine of the Mazda Mazdaspeed3 by designing a performance air intake system (69-6012TS) that unleashes a power gain of up to 24 horsepower at 5000 rpm. The 69-6012TS air intake replaces the factory air box housing with a mandrel-bent aluminum intake tube and a K&N high-flow air filter. The purpose of the custom intake tube is to smooth and straighten air flow as it enters the engine. This intake system has a large K&N high-flow air filter that is washable, reusable and flows more air than the OE air filter while maintaining filtration levels critical to long engine life.



K&N has embraced the turbocharged 2.3 liter engine of the Mazda Mazdaspeed3 by designing a performance air intake system (69-6012TS) that unleashes a power gain of up to 24 horsepower at 5000 rpm. The 69-6012TS air intake replaces the factory air box housing with a mandrel-bent aluminum intake tube and a K&N high-flow air filter. The purpose of the custom intake tube is to smooth and straighten air flow as it enters the engine. This intake system has a large K&N high-flow air filter that is washable, reusable and flows more air than the OE air filter while maintaining filtration levels critical to long engine life.

The 69-6012TS cold air intake system for the Mazda Mazdaspeed3 comes with a Million Mile Limited Warranty and is guaranteed to increase horsepower. Installation of the 69-6012TS is simple. K&N provides detailed instructions that guide you through the process. A typical install takes less than 90 minutes and only requires common hand tools

This intake system is not legal for street use in the following states:

Arizona, California, Connecticut, District of Columbia, Maine, Maryland, Massachusetts, New Jersey, New Mexico, New York, Oregon, Pennsylvania, Rhode Island, Vermont, and Washington

This intake system is legal for street use in most states. However, it is not legal for street use in California and the above states that have adopted California Emissions Standards under Section 177 of the Federal Clean Air Act of 1970. Intake systems are subject to governmental regulation in California and certain other states adopting the emission standards of the California Air Resources Board. In order for an intake system to be legal on a specific vehicle in California and the other adopting states, the part number must receive a CARB Executive Order (EO) number. This number makes the part legal for use only on specific years, makes and models of vehicles. A decal with CARB EO number for these parts must be displayed in the engine bay to satisfy smog inspection requirements.